Add gNodeB identity Which of the following MML commands is used?
In the Sub 3G band, the maximum beam number of SSBs in the NR is 16.
When gNodeB configures the UBBPfw1 baseband board, how many "slot numbers" cannot be configured?
CU/DU is set together, CU logical nodes and DU logical nodes will be added on the same BBU5900.
5G RAN 2.0 version gNodeB logical cells and sector devices use the command ANDD NRDUCELLTRP to complete the binding.
What is wrong with the description of AAU5613?
Which of the following command objects must be configured in the 5G RAN2.0 gNodeB Wireless Data Module?
Which application scenario of 5G is not described in 3GPP Release 15?
When verifying the uplink 5G Only offload effect of the NSA network, under normal circumstances, only the NR side has uplink traffic, and the rate is stable, while the LTE side tracks no rate
When a CPE device is upgraded in the near end, the firmware upgrade of the primary and standby areas can be completed at the same time as the "Update" upgrade operation.
What is the correct description of the fiber straight-pull scheme for CRAN fronthaul?
Where is the downlink data distribution in the NSA architecture implemented?
In the 5G RAN version 2.1, what is the maximum number of 100MHz 64*64 NR cells supported by a single BBU5900?
In the C-band scenario defined by R15, which of the following is the maximum wave speed of SSB in NR
Which of the following two cells has a large interference from PBCH?
In general, which of the following base station equipment commissioning methods causes the longest DownTime?
CPRI fiber is recommended to use multimode fiber when the BBU and RRU are connected more than 150 meters.
What is the length of the TTI scheduled in the 5G NR?
Which of the following models of fan boards can be adapted to the BBU5900?
What is the application type used for gNodeB remote maintenance channel detection?
gNodeB's baseband device BascbandEQM is an optional addition.
gNodeB requires two IP addresses to the same destination with the same destination mask and the same route priority cannot be the same.
When using the ACT CFGFILE command to clear gNodeB data, which product type is recommended to choose?
VSWR testing on U2000 will cause business interruption and prohibit operation when business is busy.
Regarding BWP, what is the following description correct?
When gNodeB adds NR RF unit AAU, which item should be selected for its "RF unit working standard"?
In the ADD GNBOPERATOR configuration command, which of the following configuration options can NrNetworkingOption have?
100Mhz, 64T64 cell recommended to configure how much eCPRI connection bandwidth?
The fan module of BBU3910 and BBU5900 is compatible.
gNodeB configures cell duplex mode based on band information.
The number of empty openings required for the power modules of the BBU5900 is the same as that of the BBU3900.
Which module is used in the base station power system to monitor the power environment?