New Year Special Limited Time 70% Discount Offer - Ends in 0d 00h 00m 00s - Coupon code: 70percent

CWNP CWAP-403 Certified Wireless Analysis Professional Exam Practice Test

Demo: 9 questions
Total 60 questions

Certified Wireless Analysis Professional Questions and Answers

Question 1

A PHY Header is added to the PSDU at which sub-layer?

Options:

A.

LLC

B.

MAC

C.

PLCP

D.

PMD

Question 2

Which one of the following is not a valid acknowledgment frame?

Options:

A.

RTS

B.

CTS

C.

Ack

D.

Block Ack

Question 3

What is encrypted within the fourth frame of the 4-Way Handshake?

Options:

A.

PMK

B.

PTK

C.

GMK

D.

GTK

Question 4

When configuring a long term, forensic packet capture and saving all packets to disk which of the following is not a consideration?

Options:

A.

Total capture storage space

B.

Individual trace file size

C.

Real-time packet decodes

D.

Analyzer location

Question 5

Finish the statement. It is possible to distinguish between _______and ______20 MHz transmissions when looking at an FFT plot.

Options:

A.

HR/DSSS and ERP

B.

ERP and VHT

C.

HT and VHT

D.

OFDM and HT

Question 6

A client is operating in an unstable RF environment. Out of five data frames transmitted to the client it only receives four. The client sends a Block Ack to acknowledge the receipt of these four frames but due to frame corruption the Block Ack is not received by the AP. Which frames will be transmitted?

Options:

A.

Only the data frame which was corrupted

B.

Both the corrupted data and Block Ack

C.

All data frames

D.

Only the Block Ack

Question 7

Which one of the best following is an advantage of using display filters instead of capture-time filters?

Options:

A.

Display filters allow for focused analysis on just the packets of interest

B.

Once created display filters are reusable for later captures

C.

Display filters only hide the packets from view and the filtered packets can be enabled for view later

D.

Multiple display filters can be applied simultaneously

Question 8

As a wireless network consultant you have been called in to troubleshoot a high-priority issue for one of your customers. The customer’s office is based on two floors within a multi-tenant office block. On one of these floors (floor 5) users cannot connect to the wireless network. During their own testing the customer has discovered that users can connect on floor 6 but not when they move to the floor 5. This issue is affecting all users on floor 5 and having a negative effect on productivity.

To troubleshoot this issue, you perform both Spectrum and Protocol Analysis. The Spectrum Analysis shows the presence of Bluetooth signals which you have identified as coming from wireless mice. In the protocol analyzer you see the top frame on the network is Deauthentication frames. On closer investigation you see that the Deauthentication frames’ source addresses match the BSSISs of your customers APs and the destination address is FF:FF:FF:FF:FF:FF:FF.

What do you conclude from this troubleshooting exercise?

Options:

A.

The customer should replace all their Bluetooth wireless mice as they are stopping the users on floor 5

from connecting to the wireless network

B.

The users on floor 5 are being subjected to a denial of service attack, as this is happening across the

entire floor it is likely to be a misconfigured WIPS solution belonging to the tenants on the floor below

C.

The customers APs are misbehaving and a technical support case should be open with the vendor

D.

The CCI from the APs on the floor 4 is the problem and you need to ask the tenant below to turn down their AP’s Tx power

Question 9

Protocol analyzers may present field values in either binary, decimal or hexadecimal. What precedes a

hexadecimal value to indicate it is hexadecimal?

Options:

A.

0x

B.

%

C.

HEX

D.

16x

Demo: 9 questions
Total 60 questions